Safety Information; Intended Use - Fora Diamond Cuff BP Bedienungsanleitung

Diamond CUFF BP Owner's Manual

Safety Information

Read the following Safety Information throughly before using the
device.
Use this device ONLY for the intended use described in this manual.
Do NOT use accessories which are not specified by the
manufacturer.
Do NOT use the device if it is not working properly or damaged.
Do NOT use under any circumstances on newborns, infants, or
persons who cannot communicate.
This device does NOT serve as a cure for any symptoms or diseases.
The data measured is for reference only. Always consult your
physician to have the results interpreted.
Keep the equipment away from hot surfaces.
Do NOT apply the cuff to areas other than the place directed.
Proper maintenance and periodically calibration are essential to the
longevity of your device. If you are concerned about your accuracy
of measurement, please contact local customer service for help.
KEEP THESE INSTRUCTIONS IN A SAFE PLACE
Introduction

Intended Use

The Diamond CUFF BP Blood Pressure Monitoring System is
intended to be used to measure the systolic and diastolic blood
pressure and pulse rate by using a non-invasive technique in
which an inflatable cuff is wrapped on the upper arm.
The device also works in unison with iFORA BP app that enables
transmission and sharing capabilities via Bluetooth.
Do not use this system on babies, young children or persons who
cannot express their consent.
Test Principle
Blood pressure is measured non-invasively at the arm based on
oscillometric method.
The reading obtained by single and average mode which use
oscillometic method is for reference only.
EN-1