Replacing The Blade; Ordering Replacement Parts; Disposal And Recycling; Storage - EINHELL RG-EM 1843 HW Originalbetriebsanleitung

brush or rag. Do not use any solvents or water
to remove dirt.
•
The cutting components - i.e. the knife cage
and lower knife blade - are subjected to more
wear and tear than any other component
of the unit. Therefore, routinely check the
condition of the blade and make sure that it
is tightly fastened. If the blade is completely
worn out, it must be immediately replaced or
ground sharp again. An excessively vibrating
mower means that the blade is not properly
balanced or has become deformed from
striking an object. In this case, the blade must
be repaired or replaced.
•
There are no parts inside the equipment
which require additional maintenance.

9.3 Replacing the blade

For safety reasons, we recommend having the
blade replaced by an authorized professional. Im-
portant. Wear work gloves! Only replace the blade
with a genuine Einhell replacement blade, as this
will ensure top performance and safety under all
conditions.
Carry out the following steps to change the blade:
•
Undo the fastening screw (see Fig. 11a).
•
Remove the blade and replace with a new
one.
•
When fitting the blade, make sure it is ins-
talled in the right direction. The blade's air
vanes must jut into the motor compartment
(see Fig. 11a). The dome mounts must be
aligned with the punch holes in the blade (see
Fig. 11b).
•
Then retighten the fastening screw with the
universal wrench. The tightening torque
should be approx. 25 Nm.
At the end of the season, perform a general ins-
pection of the lawn mower and remove any grass
and dirt which may have accumulated. At the start
of each season, ensure that you check the condi-
tion of the blade. If repairs are necessary, please
contact our customer service center. Use only
genuine spare parts.
Anleitung_RG-EM_1843_HW.indb 26 Anleitung_RG-EM_1843_HW.indb 26
All manuals and user guides at all-guides.com
GB

9.4 Ordering replacement parts:

Please provide the following information on all
orders for spare parts:
•
Model/type of the equipment
•
Article number of the equipment
•
ID number of the equipment
•
Spare part number of the required spare part
For our latest prices and information please go to
www.isc-gmbh.info
Spare blade art. no.: 34.054.50

10. Disposal and recycling

The unit is supplied in packaging to prevent its
being damaged in transit. This packaging is raw
material and can therefore be reused or can be
returned to the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic. De-
fective components must be disposed of as spe-
cial waste. Ask your dealer or your local council.

11. Storage

Store the equipment and accessories out of
children's reach in a dark and dry place at above
freezing temperature. The ideal storage tempe-
rature is between 5 and 30 °C. Store the electric
tool in its original packaging.
- 26 -
14.10.11 09:41 14.10.11 09:41