Technical Data; Safety And Protection Devices; Intended Use - CAMPAGNOLA LINX Bedienungs- Und Wartungshandbuch

1. Cutting bar
Supports and guides the chain.
2. Chain
Cuts branches, trunks, etc.
3. Pole connection
Allows to connect the tool and the pole.
4. Bar stop washer
Fastens the chain bar.
5. Fixing nut
Fixes the bar.
6. Front casing
Covers the pinion and fixes the chain bar.
7. Fixing screws
Fasten the front casing.
8. Bar-cover
It protects from contact with the chain.
9. Adjusting screw
Adjusts chain tension.
10. Extraction hook
Extracts cut branches.
3.4

Technical data

Chain pruner type
Chain pruner weight
Cutting bar length
Step chain/ Gauge
Pinion
Chain speed
Air consumption
Bar max. cutting size
Working pressure
Safety catch active
Setup for assembly on extension pole
3.5

Safety and protection devices

• Safety catch active (15): it is inserted automatically when releasing the operating lever (16) and prevents an invol-
untary start-up of the tool.
• Handle hand guard (14): protects the lever (16) from involuntary activations.
• Bar cover (8): protects the bar and chain during transport.
3.6

Intended use

The tool was designed and built to cut and prune orchards, vineyards, citrus groves, olive groves and all trees in general;
in the manners and with the limits described previously.
CAUTION!
• Any other use has to be considered improper and potentially dangerous for the operators' safety. This
would make any warranty claims void.
If the tool is used for purposes other than those listed, it may be seriously damaged and damage objects
•
and persons.
Page 32
11. Control handle
Allows to support and guide the tool
12. Pneumatic valve
Allows to introduce air in the motor.
13. Fitting
Allows connection to the tool's air supply pipe.
14. Rear hand guard
Protects the operator's hand.
15. Lever safety catch active
Prevents involuntary activation of the lever
16. Lever
Starts the tool when pressed.
17. Telescopic pole
Allows to work at adjustable heights.
18. Lever
Locks the extendable pole.
19. Fixed pole
Allows to work without using a ladder.
Carving
8"- 1/4"
8" 1/4" 1,1
1.2 kg 1.2 kg
8" 8" Carving
1/4" 1.3 1/4" 1.1
7 teeth 1/4"
11 m/sec
430 l/min
150 mm
10 bar (1000 kPa)
YES
YES
Use and Maintenance Manual – Translation of Original
Instructions Rev.: 01, Date 16/09/2021