Technical Specifications; Product Identification - CAMPAGNOLA LINX Bedienungs- Und Wartungshandbuch

• When maintenance or repairs have been completed, the tool can be started again only if duly authorised
by a mechanical or electric/electronic maintenance technician, who must make sure that:
- work has been completed;
- the equipment works perfectly;
- the safety devices are activated;
- no one is working on the equipment.

3 TECHNICAL SPECIFICATIONS

3.1

Product identification

The identification CE plate/label (Figure 1) is applied to each machine/tool.
The model, serial number and year of manufacture are shown on the manufacturer's CE plate and affixed on the ma-
chine. The CE plate is applied on the machine/tool and shows the data and symbols described below:
1) Conformity marking according to directive 2006/42/EC
2) Company name and complete address of the manufacturer
3) The compulsory requirement for all personnel in charge of use and/or maintenance of the tool to read the use and
maintenance manual.
4) Tool designation
5) Type of tool - Type/code designation of the tool
6) Serial number
7) Year of manufacture, i.e. the year in which the manufacturing process was concluded
8) Information pursuant with Directive "WEEE" 2012/19/EU: Electric and electronic waste may contain hazardous
substances for the environment and human health and therefore must not be disposed of with domestic waste,
they must be collected in dedicated collection centres.
9) Tool supply voltage (only for battery powered electrically supplied tools)
IMPORTANT!
IMPORTANT!
The CE marking is unique and it certifies the conformity of the product with the machinery directive
and the other applicable directives in compliance with the conditions prescribed and shown in this manual.
In case of a "composite" machine/tool a CE plate/label which identifies the type of tool (e.g. ATRA.xxxx) com-
posing the composite machine/tool is affixed to the product.
IMPORTANT!
The customer is in charge of checking the integrity of the CE plate/label.
The user must replace the CE and/or warning plates which become illegible due to wear.
It is strictly forbidden to remove the plates/labels on the machine/tool. Campagnola S.r.l declines any respon-
sibility on the safety of the machine/tool in case of non-compliance with this prohibition.
Page 30
Figure 1
Use and Maintenance Manual – Translation of Original
Instructions Rev.: 01, Date 16/09/2021