Operating instruction
9.1
Assembling the power plug
Connect the power cable to the pump as shown. Caution: Line voltage! Observe the required
protective measures, national body regulations and local provisions at all times. The cable
cross-section may no smaller than 0.75 mm2. Use ferrules if using fi ne-wire cables.
10 Filling and Venting the System
34
WITA go.future Z+
1
3
The system must be thoroughly fl ushed
before the pump is started up to prevent
contaminants or foreign bodies from
remaining in the system.
Fill and vent the system correctly.
Incomplete venting can lead to noises
in the pump and system.
Warning! Risk of burns!
The entire pump can be very hot, depending
on the operating state of the system.
Tighten the union nut with 30 Nm torque.
Use fi lter wrench.
2
Click
4
Click
Note