Pump Settings And Output; Temperature Control Without Time Switch Function - WITA go.future Z+ Original Einbau- Und Betriebsanleitung

7 Pump Settings and Output

Maximum
temperature
Minimum
temperature
Sensor
temperature
Menu key
Types of operation of the pump
The pump has three different operating modes.

1. Temperature control without time switch function

2. Timer mode (temperature control with adjustable timer function)
3. Smart mode (temperature control with preset timer values)
7.1 Temperature control without time switch function
After switching on, the „mode" symbol lights up at the bottom left of the display. The pump runs
in this operating mode 24 hours a day. When the temperature of the water in the pipeline is lower
than the set start temperature, the pump is switched on until the temperature of the water in the
pipeline has reached the set stop temperature.
Press the left menu button to enter the selection mode. In the lower part of the display flashes to
indicate the current standard mode „mode", press the button „OK" to go directly to the
temperature control mode. When the word „fashion" ends flashing and permanently lit, the
setting is complete. The temperature range can be changed as described in chapter 7.4.
WITA go.future Z+
Adjust and confirm
of settings
Operating instruction
Days of the week
Motor on / off
Timer
Smart mode
Power level
Time
Menu items
step back
29