Smart Mode - WITA go.future Z+ Original Einbau- Und Betriebsanleitung

Operating instruction
7.2 Timer mode (temperature control with adjustable timer function)
When the timer mode is switched on, the „timer" symbol lights up. For every day of the week
three switch-on and switch-off times can be set. The pump is switched on at the set time, if the
temperature of the tap water is lower than the set start temperature, and runs until the
temperature of the tap water reaches the set stop temperature.
To set the time periods, proceed as follows:
Press the left menu button „
the timer mode („Timing" is then displayed). To press The OK button. The timer symbol stops
flashing and the day of the week flashes. Choose Use the „+" „-" buttons to select the day of the
week for which you want to set the times. To confirm You this with OK. The number "1" flashes
after "Ti per". This is the first program slot for the Times can be set. You can now press the „+" „-"
buttons two more Select further program positions. Confirm the program location you want to
change with OK. Now use the „+" „-" buttons to set the hours for the switch-on time. Press it this
with OK. The minutes are now flashing and can be changed. Confirm with OK. Now the hours for
the switch-off time flash. After setting, confirm again with „OK".
You can now set the minutes for the switch-off time. Confirm again with „OK". Now The day of
the week flashes again and you can change the settings for the other days of the week make. The
settings are applied after approx. 10 seconds without pressing a button. The pump
automatically switches to normal operation and now works with the set Times. You can change
the times at any time as described.
7.3

Smart mode

Press and hold the Menu button „
the automatic symbol (Ⓐ) lights up and the pump runs by default in the set temperature range
for three periods: 6:00-9:00, 11:00-13:00, 21: 00-23: 00. If the temperature of the tap water is
lower than the set start temperature, the electric pump is switched on and runs until the
temperature of the tap water has reached the set stop temperature. The time setting can be
adjusted become. To do this, follow these steps:
With the smart mode switched on (the (Ⓐ) symbol lights up) press the left menu button „
enter the selection mode, press the „+" „-" button to switch to the timer mode („Timing" is then
displayed). Press the OK button. The timer symbol stops to flash and the day of the week flashes.
Use the „+" „-" buttons to select the day of the week for which you want to set times. Confirm
this with OK. „Ti per" flashes behind the number „1". This is the first program position for which
times can be set. you you can now select two further program positions by pressing the „+" „-"
buttons.
Confirm the program location you want to change with OK. Now use the „+" „-" buttons set the
hours for the switch-on time. Activate this with OK. Now the lights are flashing minutes and can
be changed. Confirm with OK. The hours for the switch-off time will now flash.
30
WITA go.future Z+
" to enter the selection mode, press the „+" „-" - button to enter
" for 3 seconds to turn on Smart mode. After switching on,
", to