Hilti SD 5000-A22 Bedienungsanleitung Seite 24

All manuals and user guides at all-guides.com
5.2 Inserting the battery
WARNING
Risk of injury! Inadvertent starting of the screwdriver.
▶ Before fitting the battery, check that the screwdriver is switched off and that the forward / reverse
switch is in the middle position (i.e. safety lock engaged).
WARNING
Risk of injury! Hazard presented by a falling battery.
▶ A falling battery may present a risk of injury to yourself and others. Check that the battery is
securely seated in the power tool.
WARNING
Electrical hazard! Risk of short circuiting.
▶ Before inserting the battery, check to ensure that the battery terminals and the contacts on the
screwdriver are free from foreign objects.
▶ Insert the battery.
5.3 Fitting the belt hook in the alternative position
1. Press both battery release buttons simultaneously and pull the battery out of the screwdriver.
2. Unscrew both belt hook retaining screws.
3. Bring the belt hook and threaded piece into place on the other side of the tool.
4. Reinsert and tighten the two retaining screws.
5.4 Working safely with the belt hook and universal hook
▶ Before beginning work, make sure that the belt hook and universal hook are securely attached to the
screwdriver.
▶ Use the universal hook only when necessary. Lay the screwdriver down in a safe place when it is not in
use for a long period.
5.5 Forward / reverse
Note
The control switch is locked when the forward / reverse switch is in the middle position (safety lock).
▶ Set the forward / reverse selector switch to forward or reverse rotation.
5.6 Changing the bit
1. Pull the depth gauge away from the power tool, releasing the snap-on connection.
2. Change the bit.
3. Refit the depth gauge to the power tool.
5.7 Changing the accessory tool.
1. Pull the depth gauge away from the power tool, releasing the snap-on connection.
2. Push the chuck towards the screwdriver, turning the chuck slightly at the same time, and then hold it in
this position.
3. Remove the accessory tool with your other hand.
4. Insert the desired accessory tool in the chuck, pushing it into the screwdriver as far as it will go.
5.8 Removing the battery
▶ Press both battery release buttons simultaneously and pull the battery out of the screwdriver.
18
2
4
5
6
3