Snapper ESXD19SPWM82 Bedienungsanleitung Seite 13

EN
AR BG CS DA DE ES ET FI FR HR HU IT LT LV NL NO PL PT RO RU SK SL SR SV TR UK
Do not attempt to modify this product or
create accessories not recommended for
use with this product. Any such alteration
or modification is misuse and could
result in a hazardous condition leading to
possible serious personal injury.
Do not insert switch key until assembly
is complete and you are ready to
mow. Failure to comply could result in
accidental starting and possible serious
personal injury.
To prevent accidental starting that could
cause serious personal injury, always
remove the battery pack from the product
when assembling parts.
Never operate the mower without the
proper safety devices in place and
working. Never operate the mower with
damaged safety devices. Operation of
this product with damaged or missing
parts could result in serious personal
injury.
UNFOLDING AND ADJUSTING LOWER
HANDLE
See figure 2.
■ Pull and rotate the handle knobs 90° on
both sides to loosen the lower handles
on both sides.
■ Move the lower handles to the operating
position. You may raise or lower the
handle to a position comfortable for you.
There are 3 positions for you to choose.
Release the handle knobs to lock the
lower handle into position.
NOTE: Ensure both sides are set at the
same position for proper assembly.
English (original instructions)
WARNING
WARNING
WARNING
WARNING
INSTALLING THE UPPER HANDLE
See figure 3.
■ Align the mounting holes on the upper
handle and the lower handle. Insert
the carriage bolts and use the knobs to
tighten them. Repeat the operation on
the other side.
INSTALLING THE GRASSBOX
See figure 4.
■ Lift the rear discharge door.
■ Lift the grass catcher by its handle and
place under the rear discharge door so
that the hooks on the grass catcher are
seated on the door rod.
■ Release the rear discharge door. When
installed correctly, the hooks on the
grass catcher will extend through the
openings on the rear discharge door.
INSTALLING THE MULCHING PLUG
See figure 5.
■ Lift and hold up the rear discharge door.
■ Grasp the mulching plug by its handle
and insert it at a slight angle, as shown.
■ Push the mulching plug securely into
place.
■ Lower the rear discharge door.
INSTALLING
DEFLECTOR
See figure 6.
NOTE: When using the side discharge
deflector, do not install the grassbox. The
mulching plug should remain installed.
■ Lift the side discharge door.
■ Align the hooks on the deflector with the
hinge rod on the underside of the door.
■ Lower the deflector until the hooks are
secured on the mulch door hinge rod.
■ Release the deflector and side discharge
door.
SETTING BLADE HEIGHT
See figure 7.
When shipped, the wheels on the mower
are set to a low-cutting position. Before
using the mower for the first time, adjust
7
SIDE DISCHARGE