2.3.2
Procedure for Setting Data (7-Segment Keypad)
In DRV Group:
1. Rotate the encoder knob until the desired parameter code is displayed.
2. Press PROG/ENT key to go into the programming mode, then the display blinks.
3. Press SHIFT/ESC key to move the cursor to the desired digit.
4. Rotate the encoder knob to change the data.
5. Press PROG/ENT key to enter the changed data.
In FUN1 Group:
1. Rotate the encoder knob until parameter code '20' is displayed in drive group.
2. Press PROG/ENT key to go into the FUN1 group.
3. Rotate the encoder knob until the desired parameter code is displayed.
4. Press PROG/ENT key to go into the programming mode, then the display blinks.
5. Press SHIFT/ESC key to move the cursor to the desired digit.
6. Rotate the encoder knob to change the data.
7. Press PROG/ENT key to enter the changed data.
In FUN2 Group:
1. Rotate the encoder knob until parameter code '21' is displayed in drive group.
2. Go to step 2 of 'In FUN1 Group' above, and follow the rest procedure.
In I/O Group:
1. Rotate the encoder knob until parameter code '22' is displayed in drive group.
2. Go to step 2 of 'In FUN1 Group' above, and follow the rest procedure.
All manuals and user guides at all-guides.com
23
Chapter 2 - Operation