Replacing The Light Bulb - Veripart VPTMKV85 Bedienungsanleitung

• During prolonged absences (holidays), it is advisable to disconnect the
refrigerator, remove all the food, and clean the appliance. The door should
be left slightly open to avoid the growth of mould and unpleasant odours.
• During short absences, the refrigerator can remain on. However, remember
that prolonged power outages may occur while you are gone.
Servicing
This product should be serviced by an authorised engineer and only genuine
spare parts should be used.
Under no circumstances should you attempt to repair the appliance yourself.
Repairs carried out by inexperienced persons may cause injury or serious
malfunctioning. Contact the local store where your purchase was made.
When the appliance is not in use for long periods, disconnect it from the
electricity supply, empty it of all food and clean the appliance, leaving the
door ajar to prevent unpleasant smells.

Replacing the light bulb

1. Before replacing the internal light bulb, always press and turn the
thermostat control to dial to position "OFF", then disconnect the
mains supply.
2. Hold and lift up the light bulb cover.
3. Remove the old bulb by unscrewing it in an anti-clockwise direction.
4. Replace with a new bulb (Max.10W) by screwing it in a clockwise
direction and making sure that it is secure in the bulb holder.
5. Refit the light bulb cover, re-connect your fridge to the mains supply
and switch on.
42