Operating Modes - MADRIX LUNA Kurzanleitung & Technisches Handbuch

Operating Modes

®
You can mainly use 6 operating modes together with MADRIX 5:
� DMX-OUT via Ethernet network (Art-Net)
� DMX-OUT via Ethernet network (Streaming ACN)
� DMX-OUT via USB
� DMX-IN via Ethernet network (Art-Net Remote)
� DMX-IN via Ethernet network (sACN Input)
� DMX-IN via USB
Please note: DMX-OUT and DMX-IN can be used at the same time.
You can connect MADRIX ® LUNA over Ethernet network to the network card of
the computer that runs the MADRIX ® 5 Software or directly over USB. Data is
distributed to the device via network cabling or USB cabling and sent to the XLR
output ports for output ('DMX 1 – DMX 4/8/16').
First, completely switch off your supply of power for your fixtures/the device.
®
Second, connect LED controllers/fixtures to the XLR ports of MADRIX LUNA.
®
Third, connect MADRIX LUNA and your controllers/fixtures to power.
Fourth, connect to USB or to an Ethernet network for data as required
(see p. 8 for the correct network settings for your computer).
®
Fifth, make sure to activate the correct drivers in the MADRIX 5 Software:
– For USB, go to 'Preferences' > 'Options...' > 'Devices USB',
– For sACN, go to 'Preferences' > 'Options...' > 'Devices Network',
– For Art-Net, go to 'Preferences' > 'Device Manager...' > 'Art-Net'.
Sixth, configure and activate your devices in order to send or receive data:
– Go to 'Preferences' > 'Device Manager...' > 'DMX Devices',
– Go to 'Preferences' > 'Device Manager...' > 'DMX Input'.
®
Regarding DMX input and when connecting to DMX-IN, MADRIX LUNA will
automatically send the incoming data to the connected network (or over USB).
Use the web configuration to set up all relevant settings (see p. 8).
®
For more information, please read the MADRIX 5 user manual.
9
EN