MADRIX LUNA Kurzanleitung & Technisches Handbuch Seite 6

Supply Of Power
Be careful when handling the device and electrical power! To supply the unit with
power, first connect the provided power cable to the unit ('Power') and then to
a suitable power outlet. The device uses mains voltage (AC 100 V – 240 V)!
CAUTION!
DO NOT OPEN THE UNIT. RISK OF ELECTRICAL SHOCK.
Description Of Status LED Codes
The following table describe the LED status codes on the front of the device.
S
TATUS
Powered off
Permanently green
Blinking green
S
TATUS
Powered off
Permanently green
Blinking green
S
TATUS
Powered off
Blinking green
5
EN
S LED P
TATUS OWER
Power cable not connected. � The device has no power.
Connected to power.
Bootloader activated. � Reset device / upload firmware.
S LED E
TATUS THERNET
Ethernet not connected
or the device has no power.
Connected to Ethernet.
�
No data is sent or
received over Ethernet.
Communicating over
Ethernet.
�
Sending or receiving data
over Ethernet.
S LED DMX-IN
TATUS
DMX not connected
or the device has no power.
Receiving data via DMX-IN.
�
The input port works.
�
The power is on.
S
TATUS
USB not connected
or the device has no power.
Connected to USB.
�
No data is sent or
received over USB.
Communicating over
USB.
�
Sending or receiving data
over USB.
S
TATUS
DMX not connected
or the device has no power.
Sending data to DMX-OUT.
�
The output ports work.
LED USB
LED DMX-OUT