MADRIX LUNA Kurzanleitung & Technisches Handbuch Seite 9

Device Configuration Through A Web Browser
You can access all settings and information of MADRIX
web configuration tool, in case that the device is connected to a network.
Step 1) Connect MADRIX
Step 2) Assign correct network settings for your computer in the operating
system. (Recommended default settings:
IP address 10.0.0.1 / Subnet mask 255.0.0.0)
Step 3) Open your web browser and enter the IP address of MADRIX
(You can find the default IP address on the back side of the device.)
Step 4) The web configuration tool will be launched. You will have access to
various settings, such as the IP address.
Please note: The package contents do not include network cabling.
Reset To Factory Default Settings
In rare cases, you might need to do a reset to factory default settings:
Step 1) Disconnect the device from power.
Step 2) Use a suitable tool to press the reset button on the unit's back side.
Step 3) Continue to press the reset button and connect to power again.
Step 4) Continue to press the reset button and wait until all status LEDs
on the front of the device flash repeatedly or wait 10 seconds.
Please note: Simply repeat these steps should the process fail.
How To Update The Firmware
It is highly recommended to update the firmware should a new firmware version
become available. You can update the device in different ways, for example:
Step 1) Connect MADRIX
Step 2) Start the MADRIX
Step 3) In MADRIX
A new window will open. Click on the search button (Loupe icon) and
the software will search for connected devices. Select your device in
the list, click on the 'Firmware' button, and follow any instructions.
®
LUNA and your computer to the same network.
® LUNA to your computer over USB.
® 5 Software.
® 5, go to 'Tools...' > 'MADRIX Device Configuration...'.
® LUNA using the built-in
®
LUNA.
8
EN