Operating Modes - MADRIX LUNA Kurzanleitung & Technisches Handbuch

Operating Modes

You can mainly use 6 operating modes together with the MADRIX Software:
®
 DMX-OUT via Ethernet network (Art-Net)
 DMX-OUT via Ethernet network (Streaming ACN)
 DMX-OUT via USB
 DMX-IN via Ethernet network (Art-Net Remote)
 DMX-IN via Ethernet network (sACN Input)
 DMX-IN via USB
Please note: DMX-OUT and DMX-IN can be used at the same time.
You can connect MADRIX LUNA over Ethernet network to the network card of
®
the computer that runs the MADRIX Software or directly over USB. Data is
®
distributed to the device via network cabling or USB cabling and sent to the XLR
output ports for output ('DMX 1 – DMX 4/8/16').
First, completely switch off your supply of power for your fixtures/the device.
Second, connect LED controllers/fixtures to the XLR ports of MADRIX LUNA.
®
Third, connect MADRIX LUNA and your controllers/fixtures to power.
®
Fourth, connect to USB or to an Ethernet network for data as required
(see p. 8 for the correct network settings for your PC).
Fifth, make sure to activate the correct drivers in the MADRIX Software:
®
– For USB, go to 'Preferences' > 'Options...' > 'Devices USB',
– For sACN, go to 'Preferences' > 'Options...' > 'Devices Network',
– For Art-Net, go to 'Preferences' > 'Device Manager...' > 'Art-Net'.
Sixth, configure and activate your devices in order to send or receive data:
– Go to 'Preferences' > 'Device Manager...' > 'DMX Devices',
– Go to 'Preferences' > 'Device Manager...' > 'DMX Input'.
Regarding DMX input and when connecting to DMX-IN, MADRIX LUNA will
®
automatically send the incoming data to the connected network (or over USB).
Use the web configuration to set up all relevant settings (see p. 8).
For more information, please read the MADRIX 5 user manual.
®
9
EN