Installation; Points To Be Paid Attention To When The Relocation Of The Refrigerator; Before You Start The Refrigerator - Beko RBI 2300 HCA Bedienungsanleitung

3

Installation

B
In case the information which are
given in the user manual are not
taken into account, manufacturer will
not assume any liability for this.
Points to be paid attention
to when the relocation of the
refrigerator
1. Your refrigerator should be
unplugged.Before transportation of
your refrigerator, it should be emptied
and cleaned.
2. Before it is re-packaged, shelves,
accessories, crisper, etc. inside your
refrigerator should be fixed with
adhesive tape and secured against
impacts. Package should be bound
with a thick tape or sound ropes
and the transportation rules on the
package should be strictly observed.
3. Original packaging and foam
materials should be kept for future
transportations or moving.
Before you start the
refrigerator,
Check the following before you start
to use your refrigerator:
1. Attach 2 plastic wedges as illustrated
below. Plastic wedges are intended
to keep the distance which will ensure
the air circulation between your
refrigerator and the wall. (The picture
is drawn up as a representation and it
is not identical with your product.)
All manuals and user guides at all-guides.com
2. Clean the interior of the refrigerator as
3. Connect the plug of the refrigerator
4. When the compressor starts to
5. Front edges of the refrigerator may
6. Electrical connection
socket which is being protected by a
fuse with the appropriate capacity.
Important:
with national regulations.
• The power plug must be easily
• Electrical safety of your refrigerator
• The voltage stated on the label
• Extension cables and multi plugs
8
EN
recommended in the "Maintenance
and cleaning" section.
to the wall socket. When the fridge
door is opened, fridge internal lamp
will turn on.
operate, a sound will be heard. The
liquid and gases sealed within the
refrigeration system may also give rise
to noise, even if the compressor is
not running and this is quite normal.
feel warm. This is normal. These
areas are designed to be warm to
avoid condensation.
Connect your product to a grounded
The connection must be in compliance
accessible after installation.
shall be guaranteed only if the earth
system in your house complies with
standards.
located at left inner side of your
product should be equal to your
network voltage.
must not be used for connection.