Personal Protective Equipment; Warnings And Notes; Product Symbols - Cleco mPro400GCD-P Bedienungsanleitung

1
EN

2.5 Personal Protective Equipment

(PPE)
Risk of injury by being wound up in and caught by machin-
ery
 When working with rotating parts, it is not permitted to
wear gloves.
Recommendation: Freely rotating u-GUARD pro-
tected fastening tools from APEX.
 Wear close-fitting clothing.
 Wear safety shoes.
 If necessary, wear a hairnet.
Risk of injury due to parts being ejected:
 Wear protective goggles.

2.6 Warnings and notes

Warning notes are identified by a signal word and a picto-
gram:
• The signal word describes the severity and the proba-
bility of the impending danger.
• The pictogram describes the type of danger.
Danger
A symbol combined with the word Danger
indicates a hazard with a high level of risk
which, if not avoided, will result in death or
serious injury.
Warning
A symbol combined with the word Warning
indicates a hazard with a medium level of
risk which, if not avoided, could result in
death or serious injury.
Caution
A symbol combined with the word Caution
indicates a hazard with a low level of risk
which, if not avoided, could result in minor or
moderate injuries or environmental dam-
age.
Note
An symbol combined with the word Note in-
dicates a potentially harmful situation which,
if not avoided, could result in damage to
property or the environment.
General notes
include application tips and useful infor-
mation but no hazard warnings.

2.7 Product Symbols

Be sure to understand the meaning of each symbol before
operating the controller.
6
Electrical voltage
CE compliant
The product corresponds to the prescribed
technical requirements in Europe.
Read all instructions.
NRTL TÜV SÜD Mark
4.1 Normative References, Page 9
WARNING
2.8 System-Relevant Safety Warnings
Follow national, state and local safety and connection stan-
dards during the installation. These standards take prece-
dence over the information in this section.
 Do not make any modifications to the controller, pro-
tective devices, or accessories without prior written
authorization from Apex Tool Group.
 Do not attempt to open the controller or components of
the controller for troubleshooting or other work on the
device. In the event of a fault, any intervention can
result in serious injury from electric shock.
Operation with the device open may also cause the fol-
lowing:
- An increased amount of emissions: may produce
interference with other devices.
- Reduced immunity from interference: may produce
faulty results.
- Loss of warranty.
Risk Of Injury Due To Electric Shock
The controller and tool can conduct current in the event of
a fault. An electric shock can lead to cardiac arrest, cessa-
tion of breathing, burns, and serious or fatal injuries.
 Before connecting power and tool cables, changeover,
cleaning, and removal from operation, turn off the
controller.
 Do not operate the tightening system if the housing,
cable or tool is damaged.
During The Installation
Risk Of Crushing
The controller can fall and crush parts of the body.
P2300HW | 2019-03
Disconnect mains before opening.
Apex Tool Group