Operator Training; Personal Protective Equipment (Ppe); Warnings And Notes; Symbols On The Product - Cleco mPro400GCD-P Programmieranleitung

Operator training

The tightening system may only be put into operation,
adjusted and tested by qualified and trained personnel.
The personnel must be instructed by qualified employees
of Apex Tool Group.
The nutrunner controller has been preset by
Apex Tool Group. The adjustment of the nutrunner control-
ler to special requirements may only be carried out by a
1)
qualified person .
Additional information can be found in the Programming
Manual.

Personal protective equipment (PPE)

Risk of injury by being wound up in and caught by machin-
ery
When working with rotating parts, it is not permitted to

wear gloves.
Recommendation: Freely rotating u-GUARD protected
fastening tools from APEX.
Wear close-fitting clothing.

Wear safety shoes.

If necessary, wear a hairnet.

Risk of injury due to parts being ejected.
Wear protective goggles.

2.2

Warnings and notes

Warning notes are identified by a signal word and a picto-
gram:
• The signal word describes the severity and the proba-
bility of the impending danger.
• The pictogram describes the type of danger.
CAUTION! A symbol combined with the word CAU-
TION indicates a hazard with a low level of
risk which, if not avoided, could result in
minor or moderate injuries or environmental
damage.
DANGER! A symbol combined with the word DAN-
GER indicates a hazard with a high level of
risk which, if not avoided, will result in death
or serious injury.
1. Due to their vocational training, knowledge, expe-
rience and understanding of the circumstances
involved in this kind of work, suitably qualified per-
sonnel are able to identify potential hazards and to
initiate appropriate safety measures. Qualified per-
sonnel are obliged to comply with regulations.
EN
WARNING!
A symbol combined with the word WARN-
ING indicates a hazard with a medium
1) level of risk which, if not avoided, could
result in death or serious injury.
This sign warns of a possibly damaging sit-
uation.
ATTENTION!
Failure to observe this note may cause the
product or parts thereof to be damaged.
General notes
include application tips and useful informa-
tion but no hazard warnings.

Symbols on the product

Be sure that you understand their meaning
before operation
Electrical voltage
Disconnect mains before opening.
WARNING
CE compliant
The product corresponds to the prescribed
technical requirements in Europe.
Read all instructions.
NRTL TÜV SÜD Mark
Normative References, Page 5
15
P2300HW-EN
2018-03