Cleaning And Care; Cleaning The Air Filter - Fujitsu Airstage AUXB07L Bedienungsanleitung

CLEANING AND CARE

G Before cleaning the unit, be sure to stop the unit and disconnect the power supply.
CAUTION!
G Do not stand on an unstable platform when cleaning.
G When removing and replacing the air filters, be sure not to touch the heat exchanger, as per-
G Be sure the intake grille is installed securely.
G When cleaning the unit's body, do not use water hotter than 40 °C, harsh abrasive cleansers, or
G Do not remove any part from the unit except for the filter.
G If dirt is allowed to accumulate on the Air Filter, air flow will be reduced, lowering operating

Cleaning the Air Filter

G AUXB 07/09/12/14/18/24
When the filter lamp flashes, remove and
clean the filter.
1. Push the intake grille's hooks inward to-
wards the center of the unit to open the
intake grille.
Grille Hook
2. Pull out the filter from the intake grille.
3. Clean the air filters.
Remove the dust from the air filters by vacuuming or
washing them. After washing, allow the air filters to dry
thoroughly in an area protected from sunlight.
En-5
sonal injury may result.
volatile agents like benzene or thinner.
efficiency and increasing noise.
AUXB 07/09/12/14/18/24
G
During periods of normal use, the air filters should be cleaned every two weeks.
AUXD 18/24, AUXA 30/36/45/54
G
During periods of normal use, the air filters should be cleaned every two months.
Air Filter
4. Re-attach the air filters to the intake grille.
1 Replace the air filter into its holder.
2 Make sure that the air filter makes contact with the filter
stopper when it is replaced into its holder.
Air Filter
5. Close the intake grille and push the in-
take grille's hooks outward.
Grille Hook
G Dust can be cleaned from the air filter either with a
vacuum cleaner, or by washing the filter in a solution of
mild detergent and warm water. If you wash the filter, be
sure to allow it to dry thoroughly in a shady place before
reinstalling.
G If dirt is allowed to accumulate on the air filter, air flow
will be reduced, lowering operating efficiency and in-
creasing noise.
G After turning the power on, press the filter button on the
remote control to turn off the filter lamp. (Refer to the
operation manual packed with remote control unit for
details.)
Filter Hook
Intake Grille