Cleaning The Body; When Not Using For An Extended Period - Fujitsu Airstage AUXB07L Bedienungsanleitung

G AUXD 18/24, AUXA 30/36/45/54
When the filter lamp flashes, remove and
clean the filter.
1. Push the intake grille's hooks inward to-
wards the center of the unit to open the
intake grille.
2. Pull out the filter from the intake grille.
3. Clean the air filter.
Remove the dust from the air filters by vacuuming or
washing them. After washing, allow the air filters to dry
thoroughly in an area protected from sunlight.
G Dust can be cleaned from the air filter either with a
vacuum cleaner, or by washing the filter in a solution of
mild detergent and warm water. If you wash the filter, be
sure to allow it to dry thoroughly in a shady place before
reinstalling.
G If dirt is allowed to accumulate on the air filter, air flow
will be reduced, lowering operating efficiency and in-
creasing noise.
G After turning the power on, press the MAINTENANCE
button for 2 seconds or more on the remote control.

Cleaning the body

Wash the body with warm water, and then dry with a clean and soft cloth.

When not using for an extended period

Leave the breaker on for at least 12 hours before starting operation when it is to be used again.
4. Re-attach the air filters to the intake grille.
1 Replace the air filter into its holder.
2 Make sure that the air filter makes contact with the filter
stopper when it is replaced into its holder.
5. Close the intake grille and push the in-
take grille's hooks outward.
En-6