Cleaning And Care - Fujitsu AIRSTAGE ASYA30LATH Bedienungsanleitung

CLEANING AND CARE

CAUTION!
Cleaning the intake grille and the air filter
1. Remove the intake grille and the air filter.
1 Place your fingers at the bottom of each side of the grille panel and lift forward; if the intake grille seems to catch
partway through its movement, gently continue lifting upward to remove.
2 Lift up the grille fully and remove.
3 Lift up the air filter's handle, disconnect the two lower tabs, and pull out.
1
2. Cleaning
1 Cleaning the intake grille
Remove dust with a vacuum cleaner, wash the grille with warm water, and then dry with a clean and soft cloth.
2 Cleaning the Air filter
Remove dust with a vacuum cleaner or by washing. After washing, be sure to allow it to dry thoroughly in a shady place
before reinstalling.
3. Replace the intake grille and the air filter.
1 Align the sides of the air filter with the panel, and push in fully, making sure the two lower tabs are returned properly to
their holes in the panel.
2 Holding the intake grille horizontally, fasten the two upper hooks on the unit.
3 Press the intake grille down at the lower sides to close.
1
3 3
3
En-5
9371056036-02_OM_en.p65
G Before cleaning the unit, be sure to stop the unit and disconnect the power supply.
G Do not stand on an unstable platform when cleaning.
G When removing and replacing the air filters, be sure not to touch the heat exchanger, as per-
sonal injury may result.
G Be sure the intake grille is installed securely.
G When cleaning the unit's body, do not use water hotter than 40 °C, harsh abrasive cleansers, or
volatile agents like benzene or thinner.
G If dirt is allowed to accumulate on the air filter, air flow will be reduced, lowering operating
efficiency and increasing noise.
During periods of normal use, the air filters should be cleaned every two weeks.
Intake Grille
Hooks (two places)
3 3
5
Air filter handle
Hooks (two places)
2
5/2/09, 13:03
3
2
Intake Grille