Before Operation - Mitsubishi Electric PAR-SL101A-E Serie Bedienungshandbuch Und Installation

3. Before Operation

3.1. Replacing the batteries and how to set the current time
Battery installation/replacement
1. Remove the top cover, insert two LR6 AA batteries, and
then install the top cover.
1
Top cover
After battery installation/replacement, please set clock.
Without setting clock, you cannot use a part of function of remote controller.
A
2
3
1
2
3
Two LR6 AA batteries
Insert the negative (–) end of
each battery fi rst. Install the
batteries in the correct direc-
tions (+, –)!
B
2. Press the Reset button.
Press the Reset button with an
object that has a narrow end.
How to set the current time
• The transmission mark
is transmitted.
• The indoor unit beeps to confi rm that the signal transmit-
ted from the wireless remote controller has been received
by the receiver on the indoor unit. If the indoor unit does
not beep, transmit the signal again.
1. Press the button 1. [CLOCK] A blinks.
2. Press the button 2 to set the current time.
• Press the button to increase the current time. Press
the button to decrease the current time.
• Hold down the button to increase or decrease the time
in 10-minute increments.
3. Press the button 3 to set the day.
• Each time the button is pressed, the day changes in
the following repeating order: Monday → Tuesday →
... Sunday → Monday → ...
4. Press the button 1 to confi rm the current time set-
tings.
• [CLOCK] A stops blinking and remains on, and the
current day and time are displayed.
3.2. Initial setting
Refer to 5. Initial Setting in the installation manual.
B appears each time a signal
5
en