Overheat Protection; Malfunction; Customer Service, Spare Parts; Cleaning - Dimplex EPX 500 Montage- Und Gebrauchsanweisung

6. Overheat Protection

The heater is equipped with an overheat protection for
your safety. If the air circulation is impeded, the heater
is switched off by the overheat protection. Once the
heater has cooled sufficiently, it will automatically
switch on again
In the event that the overheat protection trips re-
peatedly, the cause of overheating must be determin-
ed, e.g. air grille is covered or obstructed.
For maximum heat output it is essential that you keep
the air inlet and outlet openings free of dust. Clean the
heater with a vacuum cleaner before the start of the
heating season!
7. Malfunctions
If there is no heat output from the unit, please check
that the heater is switched on and that the thermostat is
set to the desired temperature. Subsequently check the
circuit breaker on the main service panel, or the fuse, to
ensure that they have not tripped or blown.
When a programming cassette is used check that the
program "ON" is active (also refer to the operating
instructions of the programming cassettes on the
pages that follow).
If the fault cannot be corrected, please consult the
nearest after-sales service agent.
For processing the service call, the product number
(E-number) and the manufacturing date code (FD-
number) of the heater are required. These data can be
found on the rating plate.
Repairs to the appliance, or any other interventions,
may only be performed by a qualified electrician or the
after-sales service.
Glen Dimplex Deutschland GmbH
Am Goldenen Feld 18
D-95326 Kulmbach
Subject to modifications without prior notice
www.dimplex.de/en
EPX 500, EPX 750, EPX 1000, EPX 1500, EPX 2000, EPX 2500

8. Cleaning

Before cleaning make sure that the heater is disconnected
from the power supply and that it has cooled down. Wipe the
outside of the heater with a soft, damp cloth. Do not use any
abrasive products or furniture polish for cleaning as these
may damage the surface.
Dust that may have accumulated in the heater can be
removed from the outside with a vacuum cleaner.

9. Technical Data

Supply voltage
Thermostat
Protection class I
Enclosure type
Type
EPX 500
EPX 750
EPX 1000
EPX 1500
EPX 2000
EPX 2500
10. Customer Service, Spare Parts, Warranty
Please contact your local dealer for information on
customer service and warranty conditions.

11. Disposal

The appliance should not be disposed of with
household waste, but should be taken to your
local recycling centre.
Phone number:+49 9221 709 564
Fax: +49 9221 709 589
E-Mail:09221709589@dimplex.de
www.dimplex.de/en
INDPGEELRG · 07/14/B · 07/14/B
1/N/PE~230V, 50Hz
5-30°C
PE conductor
IP X4 (splash-water protected)
Capacity Weight Width
(W) (kg) (mm)
500 5,2 448
750 6,6 618
1000 6,6 618
1500 7,1 686
2000 8,5 858
2500 10,5 858
Height Depth
(mm) (mm)
430 115
430 115
430 115
430 115
430 115
430 145
EN-11