Airwell CDMX-035N-09M25 Betriebs Und Installationsanleitung Seite 25

(B)
Refrigerant piping side
770mm / 30.3" (Suspension bolt)
830mm / 32.7"(Body)
900mm / 35.4"(Ceiling opening)
950mm / 37.4"(Panel)
CAUTION
The unit body should align perfectly with the
hole. Ensure that the unit and the hole are the
same size before moving on.
2. (A)
Drill 4 holes 5cm (2") deep at the ceiling hook
positions in the internal ceiling. Be sure to hold
the drill at a 90° angle to the ceiling.
(B)
Drill 4 holes 12cm-15.5cm (4.7"-6.1") deep at the
ceiling hook positions in the internal ceiling. Be
sure to hold the drill at a 90° angle to the ceiling.
3. Using a hammer, insert the ceiling hooks into
the pre-drilled holes. Secure the bolt using the
included washers and nuts.
4. Install the four suspension bolts.
 Page 24 
5. Mount the indoor unit. You will need two
Drain hose side
(A)
NOTE: The bottom of the unit should be
10-18mm(0.4-0.7")(
24mm (0.9")(Compact models) higher than
the ceiling board. Generally, L (indicated in
the following gure) should be half the
length of the suspension bolt or long
enough to prevent the nuts from coming o .
Ceiling board
people to lift and secure it. Insert suspension
bolts into the unit' s hanging holes. Fasten
them using the included washers and nuts.
Super-Slim models
Wall
L
10 - 18mm (0.4-0.7")
or 24mm (0.9")
) or
Main body