Scheppach 7906616701 Original Bedienungsanleitung Seite 22

• The product is not suitable for laser
welding.
• The product is not fire-resistant.
• Do not remove the ADF filter from the
welding helmet and never open the
housing of the ADF filter without author-
isation from the manufacturer.
• Prior to each use, check whether the
Welding/Grinding setting was selected
correctly.
• The cover lens must be installed on the
outer side of the ADF filter. Otherwise,
the ADF filter can get damaged.
• Do not carry out any modifications/re-
placements on the welding helmet and
ADF filter without consent.
• If the filter does not darken automatically
whilst welding please stop the operation
immediately and contact the dealers
without delay.
• Do not use any alcohol, fuel or diluting
agents to clean the ADF filter. Do not
place the ADF filter in water.
• The response time of the ADF liquid
crystal slows down if the ambient tem-
perature is lower, however this does not
have an impact on the protective func-
tions.
• This product cannot be used for over-
head welding work and cutting opera-
tions. If this product is used for overhead
welding or cutting, the molten metal
drops could burn through the ADF filter
and result in injuries to the user. .
• Exceeding the service life (insufficient
protection) – please check the protec-
tive glasses prior to each use for dam-
age and durability.
• Do not use this or any other welding
product unless you have been com-
pletely instruction in its use.
22 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
• Do not use the welding helmet if the lens
is cracked, if the lens or sensors are dirt,
or if the lens or front retaining frame is
loose.
• Keep work area clean. Cluttered areas
invite injuries
• Observe work area conditions. Do not
use welding helmets in damp or wet
locations. Do not expose to rain. Keep
work area well lit. Do not use auto-dark-
ening helmets in the presence of flam-
mable gases or liquids.
• Keep children and animals away. Chil-
dren must never be allowed in the work
area. Do not let them handle this helmet.
• Store idle equipment. When not in use,
helmets must be stored in a dry location.
Always lock up helmets and keep out of
reach of children.
• Dress properly. Do not wear loose cloth-
ing or jewellery. Keep your hair, clothing,
and gloves away from moving parts. Pro-
tective gear is essential to protect against
welding rays, some examples are a
leather welding apron,welding sleeves,
jeans without cuffs, work boots. Wear re-
strictive hair covering to contain long hair.
• Use eye and ear protection. When weld-
ing, wear approved impact safety gog-
gles under the welding helmet. Wear
an approved safety mask and ear muffs
when welding.
• Stay alert. Watch what you are doing,
use common sense. Do not weld when
you are tired.
• Check for damaged parts. Before using
any helmet, any part that appears dam-
aged should be carefully checked to de-
termine that it will operate properly and
perform its intended function. Check for
alignment and binding of moving parts,