Introduction; Layout - Scheppach 7906616701 Original Bedienungsanleitung

1. Introduction

Manufacturer:
scheppach
Fabrikation von Holzbearbeitungsmaschi-
nen GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear customer,
We hope your new tool brings you much
enjoyment and success.
Note:
According to the applicable product liabil-
ity laws, the manufacturer of the device
does not assume liability for damages to
the product or damages caused by the
product that occurs due to:
• Improper handling,
• Non-compliance of the operating in-
structions,
• Repairs by third parties, not by author-
ized service technicians,
• Installation
non-original spare parts,
• Application other than specified,
• A breakdown of the electrical system
that occurs due to the non-compliance
of the electric regulations and VDE reg-
ulations 0100, DIN 57113 / VDE0113.
We recommend:
Read through the complete text in the op-
erating instructions before installing and
commissioning the device. The operating
instructions are intended to help the user
to become familiar with the machine and
take advantage of its application possibil-
ities in accordance with the recommenda-
tions.
20 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
and replacement
The operating instructions contain im-
portant information on how to operate
the machine safely, professionally and
economically, how to avoid danger, cost-
ly repairs, reduce downtimes and how to
increase reliability and service life of the
machine.
In addition to the safety regulations in
the operating instructions, you have to
meet the applicable regulations that apply
for the operation of the machine in your
country. Keep the operating instructions
package with the machine at all times and
store it in a plastic cover to protect it from
dirt and moisture. Read the instruction
manual each time before operating the
machine and carefully follow its informa-
tion. The machine can only be operated
by persons who were instructed concern-
ing the operation of the machine and who
are informed about the associated dan-
gers. The minimum age requirement must
be complied with. In addition to the safety
requirements in these operating instruc-
of tions and your country's applicable regu-
lations, you should observe the generally
recognized technical rules concerning the
operation of woodworking machines.
We cannot accept any liability for damage
or accidents which arise due to a failure
to follow these instructions and the safety
instructions.

2. Layout

1. Helmet shell
2. Head band
3. Head band rear knob
4. Head band side knob
5. Darkening control
6. Front panel