Operation - Scheppach 7906616701 Original Bedienungsanleitung

• Maintain labels and nameplates on the
tool. These carry important safety infor-
mation.
• Stay alert, watch what you are doing,
and use common sense.
m IMPORTANT! When the welding hel-
met is turned off, not being used and/
or stored, always keep the helmet with
filter sensors downward. Other wise this
may drain the battery usage.
• Inhalation hazard: Welding and plasma
cutting produce toxic fumes:
• Exposure to welding or cutting exhaust
fumes can increase the risk of develop-
ing certain cancers, such as cancer of
the larynx and lung cancer. Some dis-
eases that may be linked to exposure
to welding or plasma cutting exhaust
fumes are:
- Early onset of Parkinson's Disease
- Heart Disease
- Ulcers
- Damage to the reproductive organs
- Inflammation of the small intestine or
stomach
- Kidney damage
- Respiratory diseases such as emphy-
sema, bronchitis, or pneumonia
Use natural or forced air ventilation and
wear an approved respirator to protect
against the fumes produced to reduce the
risk of developing the above illnesses.
m WARNING! If the Auto- Darkening Fil-
ter does not darken when the arc is struck,
immediately stop welding and consult the
owner's manual.
• Use impact resistant safety goggles and
ear protection at all times when using
24 | GB
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58
this welding helmet.
• Inspect the filter lens frequently. Imme-
diately replace any scratched, cracked,
or pitted cover lenses or filter lenses.
m WARNING! Materials that come into
contact with the wearer's skin may cause
allergic reactions in people with sensitive
skin.
m WARNING! If protection against high-
speed particles at extreme temperatures
is required, the eye protection chosen
must be labelled with the letter T directly
after the letter for the impact intensity, i.
e. FT, BT or AT. If the letter for the impact
intensity is not followed by the letter T, the
eye protection may only be used against
high-speed particles at room temperature.

6. Operation

m Note: Only use the welding helmet with
the built-in rear panel (9).
m Note: Keep the sensors (13) of the UV/
IR filter (10) clean and clear.
m Before each use check that the welding
helmet and the protective panel are intact.
If the protective panel exhibits scratches,
cracks or unevenness, it must be replaced
before use, otherwise serious injuries may
occur.
• Remove the protective film from the in-
side and outside of the visor.
• Adjust the welding helmet using the
head band (2). Turn the rear knob of the
head band (3) to adjust the welding hel-
met to the respective head size and the