Husqvarna TS138 Bedienungsanweisung Seite 25

Cutting deck
To remove and install the cutting deck
Note:
If an accessory other than the cutting deck
is to be used, the front link and the rear lift links must
be removed from the product. Also, the clutch cable
spring must be put into the cable guide on the front
edge of the lower dash.
1. Disengage the cutting deck. Refer to
and disengage the cutting deck on page 17 .
2. Stop the product. Refer to
page 16 .
3. Lower the cutting deck to the lowest position.
4. Remove the drive belt from the clutch pulley (A).
B
H
C
J
D
I
J
5. Remove the clutch cable (B), push the tab (C)
and move the clutch cable out of the bracket.
6. Carefully remove the clutch cable spring (D) from
the idler arm (E).
7. Disconnect the front link (F) from the cutting deck
and remove the retainer spring and washer.
8. Remove the clips (G) and disconnect the
suspension arms (H) from the chassis pins.
9. Disconnect the rear lift links (I) from the rear
cutting deck brackets (J) on each side of the
cutting deck.
10. Remove the cutting deck from the product.
11. Install the cutting deck in the opposite sequence.
Make sure that the discharge side is on the right
side of the product.
Note:
The suspension arms must be in
forward position before you move the cutting
deck below the product.
1701 - 001 - 10.09.2021
To engage
To stop the product on
G
A
F
G
E
H
To adjust the parallelism of the cutting deck
To do a visual side to side adjustment of the cutting
deck
If the cutting height is not the same on the right and
left side of the product, the cutting height can be
adjusted. Adjust the cutting height on the side of
cutting deck that has the lower cutting height.
1. Make sure that the tires are fully inflated.
2. Park the product on a level surface.
3. Go to the side of cutting deck that has the lower
cutting height.
Note:
adjustment.
4. Adjust the cutting height with a 3/4" wrench.
G
Note:
changes the cutting deck height 3/16" (4.7 mm).
a) Turn the lift adjustment nut (A) to the left to
lower the cutting deck.
b) Turn the lift adjustment nut (A) to the right to
lift the cutting deck.
5. Cut some grass and examine the results. Adjust
if it is necessary.
To do a precision side to side adjustment of the
cutting deck
1. Make sure that the tires are fully inflated.
2. Park the product on a level surface.
3. Put the cutting deck in the transport position.
Refer to
position or mow position on page 15 .
4. Turn the outer blade tips to align with the cutting
deck side to side.
Some models only have left side
A
Each full turn of lift adjustment nut
To set the cutting deck in transport
WARNING:
The blades on the
cutting deck are sharp and can
cause injury. Use protective gloves.
25