Displaying And Deleting Measurements - Beurer medical BM 20 Gebrauchsanweisung

6. Displaying and deleting measurements

Memory recall
You can recall stored results from the two user memories and
display averages.
• Press memory buttons M1 or M2. First the average is dis­
played of all the results held in this user memory. This is
indicated by reading .
• Continue pressing the memory button to recall other individ­
ual measurement results – the first result to appear is that of
the most recent value measured. These individual values are
indicated by memory location numbers 1 to 30. After approx.
4 seconds, the date of the respective measurement result is
displayed and then the time after a further 4 seconds.
• Once 30 individual values are in the memory, the oldest value
is deleted in order to make room for the new measured value.
• Use the on/off button to turn off the device, or it will turn off
automatically after approx. 30 seconds.
Note: You can also use the two user memories to save meas­
urement results separately, e.g. in the morning and evening.
Deleting saved values
You can delete saved values individually or else you can
delete all of them.
• To delete individual values, first select the stored value
you wish to delete and keep memory button M1 or M2
depressed. The display starts blinking. Keep holding the
button depressed until the display has completely cleared.
• To delete an entire user memory, you have to select the
appropriate user memory. The average is displayed and
All manuals and user guides at all-guides.com
7. Error recovery
Error messages may appear if
• you move or talk during measurement (
• the cuff tube is not inserted properly (
• when changing the batteries, the on/off button was pressed,
• the cuff is inflated for longer than 20 seconds (
• blood pressure is unusually high or low (
• inflation pressure is higher than 300 mmHg (
In the above cases, you must repeat the measurement. Make
sure that the cuff tube is properly inserted and that you do not
move or talk. Put the batteries back in if necessary, or else
replace them.
8. Cleaning
• Clean your blood pressure monitor carefully using a slightly
• Do not use detergents or solvents.
• On no account must you immerse the computer in water,
20
indicated with . Hold the memory button M1 or M2
depressed until the display starts blinking and keep the but­
ton depressed until the display completely clears.
display),
display),
in the display),
the display),
in the display).
damp cloth only.
otherwise liquid can enter it and cause demage.
appears in the
appears in the
appears
appears in
appears