Werbung
Faults and how to remedy them
Cause:
1. Machine skips stitches
Needle not inserted correctly.
Wrong needle used.
Needle bent or blunt.
Machine threaded rnproperly.
Needle too thin for thread used.
2. Needle thread breaks
For any of the above reasons.
Thread tension too strong.
Poor-quality or knotty thread used, or
thread that has become too dry by
excessive storage.
3. Needle breaks
Needle
not
pushed up as tar as it
will go.
Needle bent
Needle too thin or too thick,
Needle bent and strikes needle plate
because work s pushed or pulled.
Bobbin case improperly inserted.
4. Seam is not uniform
Tension out of adjustment.
Thread too thick, knotty or hard.
Bobbin thread wound unevenly.
Kinks appear on top and bottom of
material.
Push needle up as far as it will go, its
flat shank side facing toward the back
Insert system 130/705 H needle.
Insert new needle.
Check threading.
Use a more thick needle.
See par. 1 above.
Regulate thread tensions.
Use only good-quality thread.
Insert new needle and push it up as far
as it will go.
lnsert new needle.
See Needle Chart.
Let machine feed the work alone.
Only guide the material lightly.
When inserting the bobbin case, push
it
in as far as it will go.
Check upper and tower tensions.
Use first-class thread only.
During bobbin winding, do not hold
thread in hand, but pass it through the
bobbin tension stud.
Thread machine properly and check
both tensions.
Remedy:
62
Werbung
