Centering The Control Surfaces - Modster ASW28 V2 High Performance Glider Betriebsanleitung

Manual
12. Connect the main wings to the fuselage and fix them by plastic clevis. Ensure that a
sound of "click" to toghten the main wings to the fuselage.

Centering the Control Surfaces

When the transmitter is switched on and the LiPo flight battery is connected to the ESC (and
When the transmitter is switched on and the LiPo flight battery is connected to the ESC (and
installed in the battery box), it is now possible to connect the linkages to the rudder and ele-
installed in the battery box), it is now possible to connect the tappets to the rudder and treble
vator control surfaces and center them accordingly.
control surfaces and center the surfaces accordingl y .
Ensure that the elevator and rudder ( aileron ) trim are centered. Press the trim button until you Ensure that the elevator and rudder (aileron) trim are centered.
hear a short and big drop sound (a long, high drop sound means you have reached the end of
the trim on one side). When the trim levers are centeres
When the trim levers are centered, carefully open each clevis (the white colored plastic part that Once the control levers are centered, carefully open each clevis (the white colored plastic
is mounted on the threaded end of the metal pushrod) so that you can insert the pin into the
piece mounted on the threaded end of the metal pushrod) so you can insert the pin into the
outermost hole of each control screw. It may be helpful to insert a flat-blade screwdriver (not
outermost hole of each control screw. It may be helpful to insert a screwdriver (not included)
included in the scope of delivery) into the clevises to carefully turn them until it disengages the
into the fork bodies to „turn" them carefully until the pins come out of the holes in the clevises.
pin from the hole in the clevis. It is also not necessary to re-attach the clevises until the centering
It is also not necessary to reassemble the clevises until the centering adjustments are com-
settings are completed.
plete.
23
13. Plug the battery then cover the
y.
13. Plug in the battery then
close the canopy.
MODSTER ASW 28 V2
www.modster.at