Trouble Shooting - Rommelsbacher Vera SVD 1400 Bedienungsanleitung

Trouble shooting

If an error occurs, please check the following table to see if you can fix the error by yourself. If this
is not possible, please contact the service department of your dealer. Thank you very much.
Error Cause and elimination
E 1 Too few ingredients in the inner container
(only for programmes with activated heating fuction).
E 2 The filled liquid or the inner container is too hot
(all programmes except the Pulse function).
E 3 The overflow protection is active.
E 4 The appliance is overheated.
E 5 / E 6 / E 7 Error in electronics.
E 8 and EA
E 9 The motor is overloaded.
• Please pull the power plug out of the socket.
• Please fill the needed quantity of ingredients into the inner container.
Pay attention to the minimum and maximum filling quantity!
• Please reconnect the power plug to the power supply and start the
programme once again.
• Please pull the power plug out of the socket.
• Please only fill in liquids with a maximum temperatur of 45 °C.
• Please reconnect the power plug to the power supply and start the
programme once again.
• Please pull the power plug out of the socket.
• Please check the content of the inner container. To prevent the contents
of inner container from overfloating, boiling or foaming over, reduce the
contents or skim off any foam.
• Please reconnect the power plug to the power supply and start the
programme once again.
• Please pull the power plug out of the socket.
• Please let the appliance cool down and pour out hot contents if
necessary.
• Please reconnect the power plug to the power supply and start the
programme once again.
• Please pull the power plug out of the socket.
• Please reconnect the power plug to the power supply. If the error still
occurs, stop operating the appliance and get in contact with the service
department of your dealer.
• Please pull the power plug out of the socket.
• Please check the blade and the blending bell for blockage by ingredients
and remove them if necessary.
• Please reconnect the power pug to the power supply and start the
programme once again.
43