Advanced Settings - Liemke LUCHS–1 Bedienungsanleitung

Important: Make sure to remember which profile is used for which rifle. The selected
profile is displayed in the bottom left of the default screen at all times.
Important: After the alignment procedure, confirm your result by shooting a group of at
least three shots.

Advanced Settings

1. Color Mode active/inactive
Color Modes can be selectively deactivated in this submenu.
> Choose a color mode by toggling with the UP and DOWN buttons and check/un-
check it by clicking the MENU button.
> Long press the MENU button to save your settings and return to the menu.
Deactivated color modes will not show up in the Color Mode submenu in the main or
when toggling through them with a button so you only have to cycle through the color
modes that you find useful.
2. Language
> Choose between English or German menu language
3. Defective Pixel Repair
If during use there are pixels that are permanently bright ("hot pixels") and that do not
disappear after using the calibration function, you can correct these pixels by perform-
ing the Defective Pixel repair function.
Attention: Close the lens cap before performing this operation.
> Confirm (Y) by clicking the MENU button.
A countdown will appear and then a green tick mark to confirm successful Pixel Repair.
4. Restore Factory Settings
> Confirm (Y) by clicking the MENU button to reset the device to the default settings.
Attention: The G1-G3 Shot Alignment profiles will be deleted. Note the adjustment set-
tings before restoring to factory settings if you might want to use them again.
5. Device Info
Displays the serial number of the device and information about the firmware version
installed.