Liemke LUCHS–1 Bedienungsanleitung Seite 34

put. The shutter makes a very faint clicking noise and the image freezes for 0,5s during
calibration. When starting the device, automatic calibrations are performed in the first
seconds regardless of the calibration mode.
In M mode you can choose the time when the image briefly freezes, which is especially
convenient when using the device as a clip-on for shooting to ensure that the image
freeze does not occur at the moment you want to take the shot. Perform a manual cali-
bration when you observe deterioration of image quality such as graininess or banding.
S Mode is triggered by the user like M mode, but does not use the internal shutter for
completely silent operation.
Important: Close the lens cap during calibration.
WiFi
> Activate/deactivate the WiFi connection.
A WiFi symbol is displayed in the top center of the screen when WiFi is activated. For
further information about the APP and how to connect the LUCHS -1 to your mobile
device, visit: https://liemke.shop/medien
Shot Alignment
The LUCHS -1 is adjusted from the factory so that you have the same line of sight with
the device attached as a clip-on that you have with your riflescope. This means that
generally the point of impact of your rifle with the LUCHS -1 attached is very close to
the point of impact with just the riflescope. However, because attaching an addition-
al device to the riflescope can alter the vibrations of the rifle and scope during the
shot, there may be a change in point of impact with a clip-on attached. This potential
change in point of impact can be corrected in the Shot Alignment submenu.
Aligning the LUCHS -1 to your rifle
> Make sure that the scope is sighted in properly by shooting a group at your sight-in
distance without the LUCHS -1 attached
> Attach the LUCHS -1 to an adapter following the adapter manufacturer's instructions
and mount it to the scope
> Enter the Shot Alignment submenu