Installation - Elica OPEN SUITE Montage- Und Gebrauchsanweisungen

• Never use the hood without effectively
mounted grids.
• The hood must NEVER be used as a
support surface
indicated.
• Use only the fixing screws supplied with
the product for installation or, if not
supplied, purchase the correct screws type.
• Use the correct length for the screws
which are identified in the Installation
Guide.
• In case of doubt, consult an authorized
service assistance center or similar
qualified person.
WARNING! Do not use with a
programmer, timer, separate remote
control system or any other device
that switches on automatically.
Electrical connection
The mains power supply must correspond
to the rating indicated on the plate situated
inside the hood. If provided with a plug
connect the hood to a socket in compliance
with current regulations and positioned in
an accessible area, after installation. If it
not fitted with a plug (direct mains
connection) or if the plug is not located in
an accessible area, after installation, apply
a double pole switch in accordance with
standards which assures the complete
disconnection of
conditions relating to over-current category
III, in accordance
instructions.
WARNING! Before re-connecting the
hood circuit to the mains supply and
checking the efficient function, always
unless specifically
the mains under
with

installation

check that the mains cable is correctly
assembled.
The hood must be connected to the mains
supply by qualified and trained technicians.
Installation
• The minimum distance between the
supporting surface for the cooking
equipment on the hob and the lowest part
of the range hood must be not less than
55cm from electric cookers and 65cm from
gas or mixed cookers.
If the instructions for installation for the gas
hob specify a greater distance, this must be
adhered to.
• This appliance is marked according to the European directive
2012/19/EC - UK SI 2013 No.3113 on Waste Electrical and
Electronic Equipment (WEEE).
• By ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment and
human health, which could otherwise be caused by inappropriate
waste handling of this product.
• The symbol
accompanying the product, indicates that this appliance may not
be treated as household waste. Instead it should be taken to the
appropriate collection point for the recycling of electrical and
electronic equipment. Disposal must be carried out in accordance
with local environmental regulations for waste disposal.
• For further detailed information regarding the process, collection
and recycling of this product, please contact the appropriate
department of your local authorities or the local department for
household waste or the shop where you purchased this product.
Appliance designed, tested and manufactured according to:
• Safety: EN/IEC 60335-1; EN/IEC 60335-2-31, EN/IEC 62233.
• Performance: EN/IEC 61591; ISO 5167-1; ISO 5167-3; ISO
5168; EN/IEC 60704-1; EN/IEC 60704-2-13; EN/IEC 60704-3; ISO
3741; EN 50564; IEC 62301.
• EMC: EN 55014-1; CISPR 14-1; EN 55014-2; CISPR 14-2;
EN/IEC 61000-3-2; EN/IEC 61000-3-3; ETSI EN 301 489-1;ETSI
EN 301 489-17; ETSI EN 300 328; IEC 62311:2019.
Suggestions for a correct use in order to reduce the environmental
impact: Switch ON the hood at minimum speed when you start
cooking and kept it running for few minutes after cooking is
finished. Increase the speed only in case of large amount of smoke
and vapor and use boost speed(s) only in extreme situations.
Replace the charcoal filter(s) when necessary to maintain a good
odor reduction efficiency. Clean the grease filter(s) when
necessary to maintain a good grease filter efficiency. Use the
57
on the product, or on the documents