Electrical Connection; Cleaning; Storage; Maintenance - Scheppach HDA-14 Original Bedienungsanleitung

• Press the "SPEED" button twice so that the device
switches to the middle air speed.(MID button lights
up on the control panel.)
• Press the "SPEED" button three-times so that the
device switches to the slowest air speed.(LOW lamp
lights up on the control panel.)
Inserting and changing batteries in the remote
control
• Remove the battery compartment cover located on
the bottom of the remote control by withdrawing the
bracket while lifting the cover.
• Insert the batteries (type AAA) (not included in the
scope of delivery). Ensure correct polarity.
• Insert the battery compartment cover again.

10. Electrical connection

The electrical motor installed is connected and ready
for operation. The connection complies with the appli-
cable VDE and DIN provisions.
The customer's mains connection as well as the ex-
tension cable used must also comply with these reg-
ulations.
Damaged electrical connection cable
The insulation on electrical connection cables is often
damaged.
This may have the following causes:
• Pressure points, where connection cables are
passed through windows or doors.
• Kinks where the connection cable has been improp-
erly fastened or routed.
• Places where the connection cables have been cut
due to being driven over.
• Insulation damage due to being ripped out of the wall
outlet.
• Cracks due to the insulation ageing.
Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage
regularly. Ensure that the connection cables are dis-
connected from electrical power when checking for
damage.
22 | GB
Electrical connection cables must comply with the ap-
plicable VDE and DIN provisions. Only use connection
cables of the same designation.
The printing of the type designation on the connection
cable is mandatory.
For single-phase AC motors, we recommend a fuse
rating of C 16A or K 16A for machines with a high start-
ing current (from 3000 watts)!

11. Cleaning

Danger!
Disconnect the mains plug before carrying out any
cleaning work.
• Keep protective devices, air vents and the motor
housing as free of dust and dirt as possible. Rub
the device clean with a clean cloth or blow it off with
compressed air at low pressure.
• We recommend that you clean the device directly
after every use.
• Clean the device at regular intervals using a damp
cloth and a little soft soap. Do not use any cleaning
products or solvents; they could attack the plastic
parts of the device. Make sure that no water can
penetrate the device interior. Water entering a power
tool will increase the risk of electric shock.

12. Storage

Store the device and its accessories in a dark, dry and
frost-free place that is inaccessible to children. The op-
timum storage temperature lies between 5 and 30 ˚C.
Store the power tool in its original packaging. Cover the
power tool to protect it from dust or moisture. Store the
operating manual with the power tool.

13. Maintenance

Filter change (Fig. 6 - 7)
m Attention! The filter may only be changed after un-
plugging the mains plug.
• Remove the rear cover (2) by pulling it.
• Now the external filter (6) and the inner filter (7) can
be removed.
• The external filter (6) can be blown out.
• The inner filter (7) can be blown out (only to be car-
ried out outdoors!) or rinsed. The filter must be com-
pletely dry before putting it back in.
www.scheppach.com