Consumption Values - Electrolux WAL3E300 Benutzerinformation

34 www.electrolux.com
Problem
The appliance makes
an unusual noise and
vibrates.
The programme dura‐
tion increases or de‐
creases during pro‐
gramme execution.
The washing results are
not satisfactory.
Too much foam in the
drum during the wash‐
ing cycle.
After the washing cycle,
there are some deter‐
gent residues in the dis‐
penser drawer.
After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes. Deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.

15. CONSUMPTION VALUES

Stated values are obtained in laboratory conditions with relevant stand‐
ards. Different causes can change the data: the quantity and type of
laundry and ambient temperature. Water pressure, the supply voltage
and the temperature of inlet water may also affect the washing pro‐
gramme duration.
Technical specifications may be changed without prior notice to improve
the quality of product.
During the washing programme, the Prosense technology can vary the
wash duration and the consumption values. For more details see 'The
Prosense load detection' paragraph in 'Daily Use' chapter.
Possible solution
• Make sure the levelling of the appliance is correct. Refer
to "Installation instruction".
• Make sure that the packaging and/or the transit bolts
are removed. Refer to "Installation instruction".
• Add more laundry in the drum. The load may be too
small.
• The ProSense function is able to adjust the programme
duration according to the type and the laundry load size.
Refer to "The ProSense load detection" in "Daily Use"
chapter.
• Increase the detergent quantity or use a different deter‐
gent.
• Use special products to remove the stubborn stains be‐
fore you wash the laundry.
• Make sure that you set the correct temperature.
• Decrease the laundry load.
• Reduce the quantity of detergent.
• Make sure that the flap is in the correct position (UP for
powder detergent - DOWN for liquid detergent).
• Make sure you have used the detergent dispenser ac‐
cording the indications given in this user manual.