Technical Specifications - cecotec CONGA ROCKSTAR 700 ULTIMATE ERGOWET Bedienungsanleitung

ENGLISH
6. WET ACCESSORY
Before use
Take the product out of the box.
Remove all packaging materials. Keep the original box.
Make sure all the components are included and in good conditions, otherwise, contact
immediately the official Technical Support Service of Cecotec.
When you do not use the vacuum cleaner for a long time, please remove the water tank and
empty the remaining water. Do not expose it to direct sunlight or to damp environments.
Mop installation/removal
Removing/installing the water tank
Fig. 16
In order to install/remove the cleaning cloth you must first disassemble the water tank from
the rest of the appliance.
In order to remove the water tank, use your foot to hold it against the ground and pull
upwards until it unclicks from position.
Once the cloth has been installed and the water tank has been filled, to reinstall the water
tank, simply push it back together until it clicks into position.
Note: Do not use cleaning agents. Use clean and room temperature water only. Do not use
the vacuum cleaner to vacuum water.
Installing the mop cloth
Place the mop cloth on the ground with the Velcro facing upwards.
Align the mop cloth with the Velcro strips on the water tank and attach it.
Fig. 17
Water emission
Fig. 18
When using this product for the first time, make sure the water tank lid is not fully open.
When not in use, pay attention to the water emission push button and to the tank lid, as
water leak may occur when the water tank is full.
To activate water emission, the water emission push button must be pressed, and to stop
water emission, the push button must be released as shown on the following figure:
Note: If the vacuum cleaner is not going to be used for a long period of time, make sure to
remove the water tank and to empty the remaining water. Do not expose it to direct sunlight
or to damp environments.
Removing the mop cloth
To remove the mop cloth, just hold it with your hand and pull form it to detach it from the
water tank.
42 CONGA ROCKSTAR 700 ULTIMATE ERGOWET
Cleaning and maintenance
Cleaning the tank
To clean the water tank, fill the tank with clean water, shake it and then empty it.
The mop is washable; therefore, it is suggested to wash it after every use.
Replace the cloth after 20-30 uses, depending on the use.
When the mop cloth is used for a long time, it is possible that the water output is affected.
This can be avoided by cleaning both cloth and water tank regularly.
7. TROUBLESHOOTING
Problem Possible reason
The motor does not No battery.
operate. The vacuuming tube, brush,
battery, suction base or
handheld vacuum cleaner are
not assembled in place.
Suction power level is The dust tank is full.
very low. Filters are dirty or blocked.
Air inlet of the vacuuming
tube or suction base are
blocked.
The operating time after It has not been enough
charging has decreased. charged.
Battery is damaged or too old.
Green and red light The charger is not connected
blinking. to the mains.
Note: For any further doubt, please contact the official Technical Support Service of Cecotec.

8. TECHNICAL SPECIFICATIONS

Model: Conga RockStar 700 Ultimate ErgoWet
Battery: 25,9 DC, 2500 mAh
Product reference: 05494
Voltage and frequency: 100-240 V ~, 50/60 Hz
Made in China | Designed in Spain
CONGA ROCKSTAR 700 ULTIMATE ERGOWET
ENGLISH
Solution
Charge the vacuum cleaner.
Check that the components
and the handheld vacuum
cleaner are assembled
correctly.
Empty the dust tank.
Clean or replace the filter.
Clean the dirt attached to the
brush.
Charge the battery
completely.
Replace the battery.
Plug the charger to a socket
base.
43