Massoth eMotion XL Bedienungsanleitung Seite 45

All manuals and user guides at all-guides.com
increase CV61 results in an increase of time between two regulating steps. The eMOTION XL
Decoder regulates less per time unit. Depending on the motor type used a change of CV60 or
CV61 may be advisable. In addition the eMOTION XL Decoder may limit the back EMF
automatically depending on the situation.
CV62 is the back EMF adjustment strength. It defines if the Decoder is enabled to regulate up
to full load or only to a certain limit. If this value is set to "128" the back EMF is limited to 50%.
The Decoder will not continue regulating if this limit is reached thus resulting in a slower speed
if the locomotive is put on a strain. The back EMF may be switched off by CV49.
Programmable Special Functions
•
Switching speed: The maximum speed is reduced by half to facilitate a more effective driving
characteristic during switching. This feature may be set on any programmable function key.
With CV59 = 0 the function is "off". Values between 1...16 define the number of the function
key.
•
Disabling acceleration value and braking value: the programmed values of CV3 and CV4 may
be reduced to a minimum by a keystroke. With CV64 = 0 the function is "off". Values between
1...16 define the number of the function key.
•
Pause time during shuttle operation: You may utilize a simple shuttle operation by defining a
pause time in digital operation as well as in analog. With CV58 = 0 the function is "off", values
between 1...255 define the pausing time in seconds. This only works if the driving direction is
reversed. The pause time is disregarded if the locomotive is stopped and started again in the
same direction.
Light and Function outputs
•
The light and function outputs are freely programmable. (Assignment of function keys, direction
controlled functions, blinking and short-time-functions, impulse generator for sound).
•
Outputs may be programmed for NMRA-DCC-Commands or serial LGB pulses
•
All light outputs and the F1 – F4 outlets are dimmable
•
Attention: The light function depends on the programmed speed step setting. In case the CV29
setting is not matching with the setting of the DCC system, the lights blink or are not working.
36