Hook-Up To Susi-Bus; Functions And Programming; Technical Specifications - Massoth eMOTION M Bedienungsanleitung

All manuals and user guides at all-guides.com
A5 = function output 5 (-), control output for power buffer [BC]
A3 = function output 3 (-), output for RC servo control
Please find the hook-up instructions and operating instructions for the
advanced functions (RC servo, pulse simulation) in the Functions Manual.

3.3. Hook-up to SuSi-bus

The hook-up of SuSi-bus components requires soldering four wires to the
decoder.
black = GND (SuSi -)
➢
grey = RxD (SuSi-Data)
➢
Please check the CV list for the required CV settings.
3.1. Functions + programming
Please find a detailed description of the functions and the programming
options in the Functions Manual.

4. Technical specifications

Power supply: 0-24 V DC/DCC (momentary max. 27V)
Total load: Max. 2A
Motor output: Max. 1,2A, 70Hz-16KHz, load controlled, digital and analog
Light outputs: Max. 0,3A each, 22V dimmable
Function outputs 1 + 2: Max. 0,3A each, 22V dimmable
Function output 3: Max. 0,01A, 5V
Function outputs 5+6: Max. 0,05A each, 22V
(Max. 1A all light and function outputs combined)
Temperature range: -4°F - +122°F
Measurements: 27 x 14 x 6,5 mm (L x W x H)
Note: If you intend to utilize this decoder below freezing temperatures,
make sure it was stored before in a heated environment before operation
to prevent the generation of condensed water. The heat generated during
operation is sufficient to prevent condensed water.
eMOTION M Lokfahrdekoder
red = Dec+ (SuSi +)
➢
blue = TxD (SuSi-clock)
➢
14