Scope Of Supply; Basic Information For The Installation; Properties Of The Emotion M Decoder - Massoth eMOTION M Bedienungsanleitung

All manuals and user guides at all-guides.com

1.1. Scope of supply

eMOTION M Decoder with wiring for motor block
Double-sided mounting tape
Manual + CV List of the basic functions
In case one of the items listed above is damaged or missing, please con-
tact your dealer or the manufacturer directly.

2. Basic information for the installation

Install your decoder in compliance with the wiring diagram in this manual.
The decoder is protected against short circuits and excessive loads.
However, in case of a connection error e.g. a short between a light and
the motor, this safety feature cannot work and the decoder will be
destroyed subsequently.
The decoder is originally programmed to address #3 with 14 speed
steps. In case you want to use a high address, you have to program
CV17, CV18, and CV29 accordingly. If you want to use 28 speed
steps you need to add „2" to CV29. Otherwise the lights might not
work or may flicker.
In case your digital control system only supports serial data
functions, you need to set CV49 to „3".

2.1. Properties of the eMOTION M decoder

Loco driving decoder for digital- (NMRA-DCC compatible)
and analog operation (DC)
2 Light outputs (front + rear)
5 Function outputs with various programming options
Overload and overheat protection for motor control and all function
outputs
Hook-up via 4 motor block wires and 13 soldering pads
Mounting by 2 screws or double-sided tape
11 eMOTION M Lokfahrdekoder