Installation; Appliance Installation; Adjust And Secure The Tilting Angle; Handover - AEG IR Premium 6000 Bedienung Und Installation

10. installation

10.1 Appliance installation
check in chapter "Specification / data table" whether you are able to install the appliance vertically or horizontally.
» Secure the mounting bracket on the wall or ceiling using suitable fixing materials.
» Secure the appliance to the mounting bracket using the screw and nut provided.
» Route the power cable from the appliance either towards the back, top or bottom.
10.2 Adjust and secure the tilting angle
The tilting angle can be adjusted over a range of 100°. We recommend a setting of 45°.
cAution Burns
if the appliance is already in use, let it cool down before adjusting the tilting angle.
» undo both screws on the pivot hinge.
» Set an appropriate tilting angle.
» Retighten the two screws again.
» A wire is connected to the wall mounting bracket. Secure this to a wire terminal at the back of the top radiant heater.
ensure that the appliance is not in contact with the power cable.

11. Handover

Explain the functions of the appliance to the user. Draw special attention to the safety information. Hand the operating and
installation instructions to the user.

12. troubleshooting

Only use an original spare part from us if you are replacing the power cable.
Installation - for contractors
17