First Start-Up; Handover; Special Accessoriers; Electrical Connection - AEG NSH 65 Gebrauchs- Und Montageanweisung

Screw the hexagonal screws (7) into the drilled holes up to the point at which the natural stone
heating unit with the open slotted holes in its wall mountings (2) can still be hooked on behind
the screw head.
Hang the natural stone heating unit (do not allow to topple or tilt – danger of breakage) and
tighten up the hexagonal screws. In this process, take care to ensure that any stresses which
occur are compensated for by slightly loosening the securing screws (6) in the natural stone
slab.
These should subsequently be retightened up to the stop point (overtightening can cause
dowels to become loose).
2.5.2

Electrical connection

Connect the natural stone heating unit only to a 230 V 50 Hz alternating current supply.
If the mains connection lead is shortened, take care to ensure that the natural stone heating unit
can be taken off again, even without disconnecting the connection lead.
2.6

First start-up

When the natural stone heating unit is heated up for the first time, a heating-up time of
20 minutes should not be exceeded. The slab must then cool down for at least 60 minutes.
This measure is to be repeated one further time.
In the first two days, the heating should be built up to the desired room temperature in stages.
This avoids hairline cracks developing. If hairline cracks should nevertheless develop, this is not
dangerous and impairs neither the functioning nor the safety of the natural stone heating unit.
2.7

Handover

Explain the functions of the unit to the user. Draw his or her attention to the safety instructions,
in particular.
Hand the operating and installation instructions to the user.
2.8 Special accessories
Control of the natural stone heating unit is effected using the room thermostat.
RT 500: Room thermostat with thermal feedback, switching capacity 10 A 250 V.
RT 600: Room thermostat with thermal feedback, switching capacity 10 A 250 V.
RT 601 SN: Room thermostat with thermal feedback, with power switch ON/OFF,
switching capacity 10 A 250 V.
RTE 900 SN: Electronic single-circuit controller with power switch ON/OFF,
switching capacity 16 A 250 V.
3.

Guarantee

For guarantee please refer to the respective terms and conditions of supply for your country.
The installation, electrical connection and first operation of this appliance should be carried
out by a qualified installer.
The company does not accept liability for failure of any goods supplied which are not
installed in accordance with the manufacturer's instructions.
3.1

Environment and recycling

Please help us to protect the environment by disposing of the packaging in accordance with the
national regulations for waste processing.
3.1.1 Recycling of obsolete appliances
Appliances with this label must not be disposed off with the general waste. They must be
collected separately and disposed off according to local regulations.
For the Fitter
11