Software Features; Additional Information; Precautions; Moisture Condensation - Sony NV-U70T Anleitung

Software features

Install PC connection software
PC connection software (ActiveSync) can be
installed.
Backup and Restore pre-installed map
(NV-U50T/U50 only)
The map data pre-installed in the unit can be
backed up on your computer and restored to the
unit, in case of accidental deletion, etc.
Map Manager
Map data can be added to the unit from the
supplied or optional DVD-ROM. When adding,
you may need to delete unnecessary map data
from the unit to free up memory space.
Language Manager
Language data for on-screen display and voice
guidance can be added to the unit from the
supplied CD-ROM/DVD-ROM, and unnecessary
language data can be deleted from the unit.
Read the manual
You can read the manual in PDF format.
Support link
Easy access to the Sony navigation support site is
available.
Visit this site for technical support, such as
software and firmware updates, FAQs, etc.
Re-install application
The navigation software pre-installed in the unit
can be re-installed from the supplied CD-ROM/
DVD-ROM, in case of accidental deletion, etc.

Additional Information

Precautions

If your car has been parked in direct sunlight, allow
the unit to cool off before operating it.

Moisture condensation

On a rainy day or in a very damp area, moisture
condensation may occur inside the display of the
unit. Should this occur, the unit will not operate
properly. In such a case, slide the POWER switch on
the bottom right of the unit to OFF position, then
wait for about an hour until the moisture has
evaporated.
18

Note on LCD panel

Some stationary blue, red or green dots may appear
on the monitor. These are called "bright spots," and
can happen with any LCD. The LCD panel is
precision-manufactured with more than 99.99 % of
its segments functional. However, it is possible that
a small percentage (typically 0.01 %) of the
segments may not light up properly. This will not,
however, interfere with your viewing.

Maintenance

Fuse replacement

When replacing the fuse in the car battery adapter,
be sure to use one matching the amperage rating
stated on the original fuse. If the fuse blows, check
the power connection and replace the fuse. If the
fuse blows again after replacement, there may be an
internal malfunction. In such a case, consult your
nearest Sony dealer.
Fuse (2.5A)
Warning
Never use a fuse with an amperage rating exceeding
the one supplied with the unit as this could damage
the unit.

Notes on unit disposal

Remove the built-in lithium-ion battery when
disposing of the unit, and return the battery to a
recycling location.
The procedure for removing the battery is explained
below.
Note
Never disassemble the unit except when disposing of
it.
1
Switch off the main power by sliding
the POWER switch to the OFF
position.
2
Remove the jack cover (page 10).
To tighten
To remove