Description; Purpose; Overview; General Power Tool Safety Warnings - GreenWorks G24HT56 Bedienungshandbuch

EN
1

DESCRIPTION

1.1

PURPOSE

This machine is intended for cutting and trimming hedges and
bushes in domestic areas. It is not intended to be used for
cutting above shoulder level.
1.2

OVERVIEW

Figure 1.
1 Blade
2 Guard
3 Auxiliary handle
4 Trigger
2 GENERAL POWER TOOL
SAFETY WARNINGS
Read all safety warnings and all instructions. Failure to
follow the warnings and instructions may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-
operated (corded) power tool or battery-operated (cordless)
power tool.
3

INSTALLATION

3.1

UNPACK THE MACHINE

It is not necessary to assemble the machine.
• If parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove the machine from the box.
4. Discard the box and packaging material in compliance
with local regulations.
3.1.1 INSTALL THE BATTERY PACK
Figure 2
5 Rotating Button
6 Battery release button
7 Front handle switch
WARNING
WARNING
English
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and follow the instructions in the battery
and charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.1.2 REMOVE THE BATTERY PACK
Figure 2
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
4

OPERATION

• Do not put your fingers into the notches or in position
where they can get cut.
• Do not touch the blade unless you removed the battery
pack.
• Do not use the machine if the blade is damaged or bent.
• Remove all objects such as cords, lights, wire, or string
from the cutting area which can become entangled in the
cutting blade and create a risk of personal injury.
If the blade jams on an electrical cord or line, DO NOT
TOUCH THE BLADE! IT CAN BE LIFE THREATENING
AND DANGEROUS. Follow the steps below:
1. Hold the insulated rear handle or put the machine down
and away from you.
2. Disconnect the electrically service to the damaged line
or cord before you try to free the blade.
4.1

START THE MACHINE

Figure 3-4.
1. Push and hold the front handle switch with one hand and
push the trigger with the other hand.
Hold the machine with both hands during operation.
4.2

STOP THE MACHINE

Figure 3-4.
1. Release the trigger to stop the machine.
4
WARNING
WARNING
WARNING