ZAMEL EXTA FREE RZB-02 Bedienungsanleitung Seite 10

2. Press and then release transmitter's push-button.LED red diode switches on (first
signal pulsates, next the signal is constant).
3. Press and release the same transmitter's push-button. LED red diode switches on
(signal pulsates) and then switches off - THE TRANSMITTER IS ADDED.
CAUTION: Every transmitter can cooperate with RDP-01 in a different mode, de-
pending on how they were added to the device. One transmitter can be added
during one programming cycle. Full memory is signalled with pulsating LED red
diode.
TIME PROGRAMMING
1. Press PROG push-button of RDP-01 device for a longer time till LED red diode switches
on (constant signal). Next release PROG push-button. Wait (for about 5 seconds) till LED
red diode switches on (first signal pulsates, next the signal is constant).
2. Press PROG push-button of RDP-01 device and then release it. LED red diode
switches off and then switches on (signal pulsates). Every LED diode pulse equals 1
second.
3. After the adjusted time is finished (the number of LED red diode flashes) press PROG
push-button and then release it - TIME IS ADDED.
Maximum time is 18 hours.
RADIO TRANSMITTERS DELETION
1. Press PROG push-button of RDP-01 device for a longer time.
2. After 5 seconds LED red diode switches on (signal pulsateas) and then it switches off.
3. Release the push-button in RDP-01 - MEMORY IS DELETED.
COOPERATION AND OPERATING RANGE
RDP-01 ROP-02 ROB-01 SRP-02 SRP-03 RWG-01 ROM-01 ROM-10 RDP-01 RTN-01
RNK-02 180 m
RNK-04 180 m
P-256/8 230 m
P-257/4 (2) 180 m
RNM-10 230 m
RNP-01 160 m
RNP-02 160 m
RNL-01 160 m
RTN-01 200 m
RCR-01 160 m
RXM-01 230 m
* 1-channel transmitters do not cooperate with roller blind controllers
CAUTION: The given range concerns open area - an ideal condition without any
natural or artificial obstacles. If there are some obstacles between a transmitter
and a receiver, it is advisable to decrease the range according to: wood and plaster:
from 5 to 20 %, bricks: from 10 to 40 %, reinforced concrete: from 40 to 80 %, metal:
from 90 to 100%, glass: from 10 to 20 %, Over- and underground medium and high
electrical power lines, radio and television transmitters, GSM transmitters set close
to a device system have also a negative influence on the range.
200 m 200 m 200 m
200 m 200 m 200 m
250 m 250 m 250 m
200 m 200 m 200 m
250 m 250 m 250 m
180 m 180 m 180 m
180 m 180 m 180 m
180 m 180 m
200 m 200 m 200 m
180 m 180 m
250 m 250 m 250 m
200 m 250 m
200 m 250 m
250 m 300 m
200 m 250 m
250 m 300 m
180 m 200 m
180 m 200 m
-* -* 200 m
200 m 250 m
-* -* 200 m
250 m 300 m
250 m 250 m 180 m
250 m 250 m 180 m
300 m 300 m 230 m
250 m 250 m 180 m
300 m 300 m 230 m
200 m 200 m 160 m
200 m 200 m 160 m
200 m 200 m 160 m
250 m 250 m 200 m
200 m 200 m 160 m
300 m 300 m 230 m
250 m
250 m
300 m
250 m
300 m
200 m
200 m
200 m
250 m
200 m
300 m