Charging Process; Autostart; Stand-Alone With Rfid Recharge Activation - Gewiss JOINON I-ON Serie Installations- Und Bedienungsanleitung

Gewiss

10. Charging process

The steps needed to carry out a recharging session are listed below, on the basis of the various operating modes.

10.1. Autostart

In this mode, the station is always accessible and ready to begin a recharging session as soon as the car connection plug is inserted. To
enable a recharging session:
#
1 Make sure there are no errors on the charging station
Insert the recharging plug in the required socket-outlet
2
Once the connection has been made, the station checks the CP
3
and PP signals to make sure the session can be started
Once the CP and PP signals have been checked, the recharging
4 station will mechanically block the plug in the socket-outlet.
5 The car is asking the charging station for energy
6
7 To end the session, disconnect the charging cable from the car*.
8 Remove the plug from the socket-outlet on the station
9 If the station detects no errors, it will return to standby
*NB: To end the charging session, stop it first on the car (the method will change depending on the car model; we suggest you refer to
the manual of your vehicle to find the right method). The cable can now be removed from the car, terminating the charging operation.
The station will now allow you to remove the plug.

10.2. Stand-Alone with RFID recharge activation

In this mode, the station activates the session once an RFID card enabled for recharging has been swiped across the reader (i.e. added
to the local list of authorised cards).
A. ADDING SINGLE RFID CARDS TO THE LOCAL LIST
#
Swipe the MASTER key across the RFID reader to access
1
Swipe each single card that you want to add to the list across
2
the RIFD reader (wait for the relative message on the display).
To quit the RIFD card storage menu, swipe the MASTER key across
3
the RFID reader until the standard message appears
72
Action to be carried out
of the station and in the vehicle
The recharging session begins
Recharging session in progress
Action to be carried out
the storage menu
RGB LED status Words on the display
INSERT THE PLUG TO BEGIN
Fixed green
INSERT THE PLUG TO BEGIN
Fixed green
Fixed green
Flashing blue
RECHARGE IN PROGRESS
Fixed blue
RECHARGE IN PROGRESS
Fixed blue
RECHARGE IN PROGRESS
From fixed or flashing blue
to flashing green
From flashing green
to fixed green
INSERT THE PLUG TO BEGIN
Fixed green
RGB LED status Words on the display
Fixed green
Fixed green
Fixed green
7.55.4.515.2 - Installation and Operation Manual
Charging process
THE RECHARGE
THE RECHARGE
PLEASE WAIT
PLEASE WAIT
Ts=0000 Tc=0000
Ts=0000 Tc=0000
Ts=0000 Tc=0000
RECHARGE TERMINATED
REMOVE THE CABLE
SESSION SUMMARY
Ts=0000 Tc=0000
THE RECHARGE
*SAVING*
SWIPE THE CARDS
RECOGNITION
*PLEASE WAIT*
SWIPE THE CARD
TO RECHARGE