Status Indicators; Rgb Led; Alphanumerical Display - Gewiss JOINON I-ON Serie Installations- Und Bedienungsanleitung

Gewiss

9. Status indicators

Depending on the operating modes available on the model purchased, the recharging station will have at least one tool for informing the
client about the status and the actions to be carried out.

9.1. RGB LED

The recharging station has 2 RGB LEDs, one for each side and socket-outlet. Their colour changes to inform the client about the status
of the station and the actions that need to be carried out. The colour change may be on one side only or on both, depending on the
situation.
Light
Fixed green
Flashing green
Fixed blue
Flashing blue
Fixed red
None

9.2. Alphanumerical display

Each socket-outlet has a display showing various items of information that help the client understand the station status and the actions
required.
Words on the display
SWIPE THE CARD
TO RECHARGE
CARD ENABLED
*PLEASE WAIT*
*ATTENTION*
CARD NOT VALID
CARD ENABLED
CONNECT THE CABLE
RECHARGE IN PROGRESS
Ts=0000 Tc=0000
RECHARGE IN PROGRESS
kW=00.00 kWh=00.00
RECHARGE TERMINATED
REMOVE THE CABLE
SESSION SUMMARY
Ts=0000 Tc=0000
SESSION SUMMARY
kW=00.00 kWh=00.00
OUT OF SERVICE
DUE TO TECHNICAL PROBLEMS
Words on the display
*SAVING*
SWIPE THE CARDS
70
The station is ready to start a charging session. No problem detected.
The station is waiting for the charging plug to be connected,
and the connection with the car
The charging station is waiting for the charging cable to be removed, d
isconnecting the car and ending the charging session.
The charging session is in progress and the car is absorbing energy.
The charging session is in progress, but the car is not absorbing energy
(charging terminated, or car not ready for recharging).
An internal error or a connection error with the car was detected by the station
and the charging process cannot be continued.
The station does not have the necessary electrical power supply.
CHARGING PROCESS
In RFID mode, the station waits for an RFID card, checks it is valid,
and then begins the recharging process.
The RFID card has been recognised by the system.
The RFID card has not been recognised, so the recharging session cannot be started.
The station is waiting for the charging plug to be connected,
and the connection with the car.
The session is in progress and the display shows the stationary time (Ts)
and the charging time (Tc).
The session is in progress and the display shows the power dispensed (kW)
and the energy absorbed by the car (kWh)
The session has ended and the station is waiting for the cable to be removed.
When the cable is removed, the station shows
a summary of the session that has just ended.
When the cable is removed, the station shows
a summary of the session that has just ended.
There is an error that prevents starting or continuing
the charging session and therefore it will be ended.
LOCAL RFID CARD CONTROL
Once the MASTER card has been swiped, the station goes into acquisition mode. Swipe
one RFID card at a time so it can be read and added to the local White List.
Description
or
Description
Description
7.55.4.515.2 - Installation and Operation Manual
Status indicators