Device Handling; Transport; Unpacking - Gewiss JOINON I-ON Serie Installations- Und Bedienungsanleitung

Device handling

5. Device handling
During transportation, the device must be protected against mechanical shock, vibrations, water spray (rain), and any other product
or situation that could damage it or alter its behaviour.
When moving the devices, keep them horizontal.
Do not put pressure on the recharging socket-outlets.

5.1. Transport

Handling with a pallet truck
At least the following provisions must be observed:
1. Set the stations down (still packaged) in a central position in relation to the forks.
2. Position them as close as possible to the point where the forks are joined to the upright.
3. In any case, respect the instructions given in the pallet truck user manual.
Handling with a forklift
At least the following provisions must be observed:
1. Set the stations down (still packaged) in a central position in relation to the forks.
2. Position them as close as possible to the point where the forks are joined to the upright.
3. Make sure the forks are perfectly levelled, to avoid any risk of the device tipping over.
4. In any case, respect the instructions given in the forklift user manual.
Only unpack the charging station after bringing it to the place of installation, when you are ready to install it.
At this point, it can be transported vertically and without its packaging, but only for a short distance.
Handling the unpackaged device
At least the following provisions must be observed:
1. Follow the fundamental ergonomic recommendations to avoid injuries when lifting weights.
2. Do not release the device until it is perfectly fastened or positioned.
3. Follow the instructions of another person who guides the movements to be made.

5.2. Unpacking

The correct handling of the charging stations is very important to:
• Avoid damaging the packaging that maintains their optimum condition, from shipment to the moment they are installed.
• Avoiding knocking or dropping the charging stations as this could jeopardise their mechanical properties.
• Avoid, as far as possible, the vibrations that could cause subsequent abnormal operation.
To allow the installer to prepare the column fixing area beforehand, the base is inserted in the packaging in such a way that it can
be taken out separately from the charging unit. The base can therefore be removed from the packaging and installed on the ground,
attached to the tie-rods embedded in the cement or to the anchor plugs already fitted in the ground (as shown below):
Packaging disposal
The packaging is 100% cardboard, and can be taken to an authorised sorted waste collection point.
7.55.4.515.2 - Installation and Operation Manual Installation and Operation Manual
Gewiss
IT
EN
FR
ES
DE
RO
HU
NL
55