Power Supply Unit Section - dB Technologies VIO W10 Bedienungsanleitung

7. RDNet DATA IN
RDNet data input compatible with network cables with etherCON/RJ45 connectors.
"Data in" must be connected to devices such as RDNet Control 2 or Control 8.
8. RDNet DATA OUT
RDNet data output compatible with network cables with etherCON/RJ45 connectors.
"Data Out" is used to link the network to other loudspeakers in daisy-chain configuration.
9. RDNet CONTROL LEDs
LEDs relating to module network operation (RDNet).
In particular, if "Link" is on the RDNet network is active and has acknowledged the device, if "Active" is flashing
there is data traffic, if "Remote Preset Active" is on all local control on the amplifier panel are by-passed by the
RDNet remote control.
10. SERVICE DATA USB PORT
This standard Mini-USB Type-B port enables user to update product firmware using a PC and USB BURNER
MANAGER. More details are available at http://www.dbtechnologies.com under "DOWNLOADS" and in section
FIRMWARE UPDATES.

POWER SUPPLY UNIT SECTION

11. AUTO-RANGE MAINS INPUT
POWERCON® connector input.
12. "MAINS LINK" POWER OUTPUT
This connector is intended to supply power to a second module.
13. MAINS FUSE
Mains fuse.
ATTENTION!
• The fuse installed at the factory is rated for operation in the 220-240 V
voltage range. If you need to operate the speaker in the 100-120 V range:
1. Disconnect all connections, including the power supply connection.
2. Wait 5 minutes.
3. Replace the fuse with the fuse rated for the 100-120 V range, which is included in the package.
4. Use only the supplied power supply cable.
• Use the SERVICE DATA USB port to update product firmware only. Do not connect
any USB devices to the unit to avoid damage or malfunctioning.
VIO W10
24
English
Code 420120291 REV.1.0